Building Ceylon
24 February 2015This is a long overdue post about Ceylon, another Shantea Controls controller, only this time, one that I’ve built for myself. Of course, it’s based on OpenDeck platform.
Assumptions
02 December 2014In this post, I’m going to talk about collection of libraries that make up the OpenDeck platform, and why it’s important to really understand your code well.
OpenDeck SysEx protocol - stable!
09 October 2014Last time I wrote about OpenDeck SysEx protocol, there were still many unsolved problems and issues, together with lack of functionality. Since I actually released OpenDeck software on GitHub couple...
Sensimidia MIDI controller
06 September 2014Sensimidia is third Shantea Controls controller, and also my second commercial project. I’ve been working on it for the last two months, but most of that time I did nothing,...
Building OpenDeck - SysEx protocol
30 August 2014MIDI is a great protocol. One if its best features is System Exclusive message - the only type of message in MIDI protocol which doesn’t have defined message length, that...
Building OpenDeck platform, part 1
11 August 2014I’ve been real quiet about this project for more than a month, but not because I haven’t done anything. Quite the opposite, I literally got consumed by work invested in...
Announcing OpenDeck platform
03 July 2014In the last few days, I’ve finally put all of my ideas into one, coherent project called OpenDeck. For those of you who don’t already know, OpenDeck started as my...
Building Anandamidi, part 4
25 June 2014This is the last post about Anandamidi, I promise! So, in case you forgot, this is the remaining stuff to finish the controller:
Building Anandamidi, part 3
01 June 2014Like last time I posted here, there’s been much progress. In fact, the controller is already working, even though everything isn’t finished yet. So, let’s start where we finished last...
Building Anandamidi, part 2
05 May 2014Lots of progress since my last post. I got the plate, already placed most of the components, finished software and just today I made some final adjustments to PCB.